Videotec WASPT Serie Manuel D'instructions page 20

Identify the groove with the positioning pin (08)
for fastening the bracket of the nozzle (10). Remove
the fastening screw (09). Position the bracket of the
nozzle (10) using the positioning pin (08) and fasten
it with the previously removed screw (09). Refer to
the PTZ camera manual for the tightening torque of
the screw.
Insert two metal clips (11) in the bracket (10), insert
the semi-rigid pipe (12) between the clips and
tighten the screws of the two clips.
08
09
Fig. 32
To calibrate the jet, orientate the nozzle towards the
window of the PTZ camera.
To start the wash system refer to the PTZ camera
manual.
18
10
11
6.11 Washer installation (NVX
range)
Installation examples (6.13 Examples of
washer installation, page 20).
The product, if equipped with a wiper, can be
equipped with an external pump that provides
water to clean the glass.
Fig. 33
12
To complete installation of the washing system, use
the kit supplied with the camera.
Insert the head of the nozzle (01) on the support (02)
by tightening the nut (03).
Fig. 34
Fasten the nozzle and the support assembled by
using one of the accessory holes (01) on the front of
the housing. Tighten the screw and the washer (02).
Insert the delivery pipe of the nozzle (03). Secure the
delivery pipe to the support with a clip (04).
Fig. 35
To start the wash system refer to the camera manual.
02
03
01
01
02 03
MNVCWASPT_2222_EN
04