Videotec WASPT Serie Manuel D'instructions page 16

6.7 Washer installation (ULISSE
range)
To fasten the base to the support, use the
screws (05), the washers (06), the gaskets
for screws (07) and the gasket (08).
Installation examples (6.13 Examples of
washer installation, page 20).
Having fastened the support (01), arrange the
washer pipe support (supplied with the PTZ camera)
(03) in the desired position.
Insert the cables inside the support so that they
protrude by about 50cm. Insert the cable in the
cable glands (02). Keeping the base (04) at about
20cm (7.9in) from the support, lock the cable glands.
Set the base up on the stand arranging the cables
inside.
Fasten the base on the support using the screws
supplied with the PTZ camera (05).
Fig. 14
Cut the cables to size and either restore or make the
connections to the positioning unit.
14
02
07
01
06
05
Shorten the semi-rigid washer pipe (01) as needed.
Unscrew the nut (02) from the joint and slide it along
the pipe. Insert the end of the pipe into the ogive
(03).
Fig. 15
Lock the nut to the coupling.
Fig. 16
Tighten the delivery joint.
04
03
08
Fig. 17
Unscrew the knurled nut (01) from the delivery joint
(02). Insert the knurled nut on the delivery pipe (03).
Insert the end of the delivery pipe into the spinner
(04). Lock the nut to the coupling.
02
Fig. 18
02
01
01
04
MNVCWASPT_2222_EN
03
03