Bleeding The System; Bleeding The Pump - Nilfisk Booster 40-3 Mode D'emploi

4.4 Bleeding the pipe system
1. Turn on the water supply to rinse and bleed the entire system.
2. If satellites are installed open the tap furthest away until no air or dirt
comes out.
3. Now rinse and bleed the next tap and continue until the tap closest to
you has been rinsed and bled.
4. Mount the satellites, if any.

4.5 Bleeding the pump

1. Press "OFF" on the control panel to stop the booster.
2. Loosen the relief plug (A) 1-2 revolutions until water and air begin to flow
NOTE:
Never loosen the relief plug while the pump is running as this
may damage
3. Tighten the relief plug
4. Start the pump so that all remaining air pockets are forced to the top of
the pump.
5. Stop the pump
6. Loosen the relief plug 1-2 revolutions and bleed the system until only
water flows out.
7. Tighten the relief plug - The booster is now ready for operation.
8. Press "ON" on the control panel.
7