Solo 582 Manuel D'utilisation page 18

- For safety reasons, replace worn or damaged
parts.
- Wear gloves when working near the blade (with
plug cap disconnected).
- Cleaning the mower and maintenance work on
the mower can only be done with stopped engine
and disconnected plug cap.
- For warranty and safety purposes, only use origi-
nal SOLO parts for any repairs.
Supply check
1 SOLO Mower
1 Grass catcher frame
1 Grass catcher
1 Plastic bag containing:
1 Operating Manual
1 Engine Manual
2 Star handles M8
2 Washers 8.4 dia.
2 Coach bolts M8x45
1 pc combi wrench
Assembly
The mower is ready for operation with only a few as-
sembly steps. The lower handle part is secured with
handle pins (see picture 2) and firmly held in place by
the clamping block in the mower housing. Loosen both
star handles M8 and insert the clamping block into the
mower housing until flush. Tighten the star handles.
(see picture 4).
Connect the upper handle with the lower handle and
secure on both sides with coach bolts 8x45 and washers
8.4 mm dia.. Tighten with star handles on the inside of
the handle (see picture 3).
Secure both bowden cables with cable clips to the handle.
Ensure the cables are free of any sharp
bends and are not damaged.
18
Placing starter handle in rope guide
Release the engine brake by pushing the brake lever
against the mower handle. Slowly pull the starter handle
and rest handle in rope guide on the upper handle (see
picture 7).
Note: Take care when folding and unfolding the
handles to ensure that cables are not damaged in any
way.
Folding of Handle
To fold the handle,
- disconnect starter rope from rope guide (pos. 4)
- loosen both clamping blocks with star handles and
pull out from mower housing
- place lower handle to the rear of the mower
- loosen handles (pos. 15 and
- fold upper handle towards the front.
Grass Catcher
Caution: Install and remove catcher only
with stopped engine!
Pull the catcher over the frame and attach plastic re-
taining flaps in the sequence 1-2-3-4 to the frame (see
picture 5)/
Squeeze the upper frame of the catcher to allow the
carrying bracket to be fitted (see picture 6).
To fit the catcher (pos. 6), lift the rear flap (pos. 7), rest
the catcher frame on the lower guide of the mower
housing (1) , lift catcher upwards (2) until the catcher
completely locks in the discharge flap (pos. 7) (see
picture 8).