marklin 60983 Mode D'emploi page 32

CV Explanation
21 PoM Functions F1 - F8 when using multiple unit
22 PoM Functions FL, F9 - F15 when using multiple unit
Braking mode:
Bit 0 - 3 : always 0,
27 PoM Bit 4 : DC voltage, polarity against the direction of travel
Bit 5 : DC voltage, polarity with the direction of travel
Bit 6 - 7 : always 0
Configuration:
Bit 0 : reverses direction properties of the locomotive
0 = normal direction, 1 = inverse direction
Bit 1 : speed level 14 or select 28/128
29 PoM 0 = 14 speed levels, 1 = 28/128 speed levels
Bit 2 : turn analog operation off/on
0 = analog off, 1 = analog on
Bit 5 : select short / long address
0 = short address, 1 = long address
31 PoM Index high Byte
32 PoM Index low Byte
Alternative formats:
Bit 0 : Analog AC off = 0 / Analog AC on = 1
50 PoM Bit 1 : Analog DC off = 0 / Analog DC on = 1
Bit 2 : fx (MM) off = 0 / fx (MM) on = 1
Bit 3 : mfx off = 0 / mfx on = 1
32
Values Default Notes
0 = func. # only for locomotive address
0 - 255 0 1 = func. # also for multiple unit address
Bit 7-0 = [ F8 F7 F6 F5 F4 F3 F2 F1 ]
0 = func. # only for locomotive address
0 - 255 0 1 = func. # also for multiple unit address
Bit 7-0 = [ F15 F14 F13 F12 F11 F10 F9 FL ]
0 - 48 Braking subject to direction:
0 - only Bit 4 : normal DC properties
0 / 16 48 - only Bit 5 : inverse DC properties
0 / 32 Braking not subject to direction:
0 - Bit 4 + 5 : 3 rail properties
0 - 39
0 / 1
The direction properties refer to the direction
of travel and the lights. The number of speed
0 / 2 levels and the light bit depend on the locomo-
6 tive controller.
0 / 4
Either the short main address or the long
0 / 32 expanded address as a locomotive address.
16 16
This is required for advanced settings, such as
CV 300 – 328.
0 0
0 - 15
0 / 1
Note:
0 / 2 15
DCC cannot deactivate itself.
0 / 4
0 / 8