marklin 60983 Mode D'emploi page 31

CV
Explanation
1 Main address
2 PoM Minimum speed (Vmin)
3 PoM Acceleration delay (AV)
4 PoM Braking delay (BV)
5 PoM Maximum speed (Vmax)
Automatic Calibration
7
Hersteller Versionsnummer (Softwareversion)
Manufacturer identification / ID
8
Decoder reset (default or factory setting)
13 PoM Functions F1 - F8 with an alternative track signal
14 PoM Functions FL, F9 - F15 with an alternative track signal
17 Expanded address, higher value byte
18 Expanded address, lower value byte
19 Multiple unit address
CV Table for DCC
Values Default Notes
3
1 - 127
0 - 255 4
0 - 255 12
0 - 255 12
0 - 255 180
–
131
8
1
0 - 255
0 - 255 1
192 - 231 192
0 - 255 128
0 - 255 0
Short address 1 - 127
If CV 29 / Bit 5 = 0
Value must be lower than Wert muss Vmax,
CV 5. (see CV 67)
CV value multiplied by 0.9 gives the time from
being stopped to maximum speed.
CV value multiplied by 0.9 gives the time from
maximum speed to being stopped.
Speed at the highest speed level.
Value must be higher than Vmin, CV 2.(see
also CV 94)
Enter Value 77. Value 77 is not stored conti-
nuously.
Read only
Value cannot be read
0 = Func. MM or analog off
1 = Func. MM or analog on
[ F8 F7 F6 F5 F4 F3 F2 F1 ]
0 = Func. MM or analog off
1 = Func. MM or analog on
[ F15 F14 F13 F12 F11 F10 F9 FL ]
Long address 1 - 10239 (128)
If CV 29 / Bit 5 = 1
1 - 127 = multiple unit address
0 = no multiple unit
+128, Bit 7 = reverse polarity for direction
when using multiple unit
31