Heidolph Hei-MIX Titramax 100 Notice D'instructions page 43

Operation
WARNING
Risk of injury, risk of damage to property caused by splas-
hing fluids
When using open vessels, there is a risk that fluid will spray out at
high shaking frequencies.
➜
➜
➜
Automatic restart
When the mains is restored after a power interruption, the device
automatically starts up again with the set parameters!
Depending on the setting and structure, there is a risk that the
device will move uncontrolled and/or fluid will be sprayed out of the
vessels.
➜
Continuous mode
In continuous operation, the shaking movement starts as soon as the device is switched
on via the main switch.
➜ Place the vessel(s) on the shaking platform. Observe the instructions in section
"Attachments" on page 39.
➜
Turn on the device.
➜ Use the 'shaking frequency adjustment' rotary knob (see section "Mechanical
design" on page 37) to adjust the shaking frequency.
➜
The shaking movement stops as soon as the device is switched off via the main
switch.
Timer mode
In timer operation, a specific period of time (up to 120 minutes) can be set for contin-
uous shaking.
➜ Place the vessel(s) on the shaking platform. Observe the instructions in section
"Attachments" on page 39.
➜ Use the 'time adjustment' rotary knob (see section "Mechanical design" on page
37) to set a desired time for shaking operation.
➜
Turn on the device.
➜ Use the 'shaking frequency adjustment' rotary knob (see section "Mechanical
design" on page 37) to adjust the shaking frequency.
➜
The shaking movement stops as soon as the specified time has elapsed.
The shaking movement can be stopped manually at any time in
timer mode if required. To do this, switch off the device using the
main switch.
Whenever possible, use closed vessels for processing corrosive,
toxic or biohazardous substances and seal them safely.
Increase the speed only gradually to the desired shaking
frequency, especially with open vessels, and observe the fluid
movements.
Always use the necessary and appropriate personal protective
equipment!
In the event of an interruption to the mains supply, switch off
the device via the main switch.
42