Selecting The Input Mode - Yamaha YSP-1100 Mode D'emploi

You can select the type of audio input signals of the selected input source according to your preference or the conditions
of the input source.
y
We recommend setting the input mode to AUTO in most cases.
STANDBY/ON
STB VCR
INPUT1
TV
AUTO
VOL MODE SETUP INPUTMODE
1
Set the operation mode selector to YSP to
switch to the operation mode of this unit.
TV/AV
YSP
2
Press one of the input selector buttons on
the remote control to select the desired input
source.
STB VCR
TV
3
Press INPUTMODE on the remote control
repeatedly to toggle between input modes.
INPUTMODE
TV AUTO DVD AUTO
TV DTS DVD DTS
TV ANALOG
When TV or STB When DVD is
is selected as selected as the
the input source input source

SELECTING THE INPUT MODE

POWER POWER
AV TV
DVD AUX
TV
INPUT2 MACRO
SLEEP
DVD AUX
AUX AUTO
AUX DTS
When AUX is
selected as the
input source
Notes
• The input mode of VCR is fixed to ANALOG. However, if the
TV OPTICAL IN jack of this unit is assigned to VCR, AUTO,
DTS and ANALOG become available as the input mode of
VCR (see page 68).
• ANALOG is not available as the input mode of DVD and AUX.
• AUTO
Automatically selects audio input signals in the following
priority order:
1) Dolby Digital or DTS
2) PCM
3) Analog
Use this input mode in most cases.
• DTS
Selects only digital signals encoded in DTS.
Compared to AUTO, this input mode provides greater
stability while playing back CDs or LDs encoded in DTS.
• ANALOG
Selects only analog signals.
Even when both digital and analog signals are input
simultaneously, only analog signals are selected.
y
You can adjust the default input mode to be selected when the
power of this unit is turned on (see page 69).
SELECTING THE INPUT MODE
75
En