Yamaha YSP-1100 Mode D'emploi page 71

• Select COMPONENT (1) to assign components to the
STB COMPONENT VIDEO IN jacks of this unit.
Choices: TV, VCR
• Select COMPONENT (2) to assign components to the
DVD/AUX COMPONENT VIDEO IN jacks of this
unit.
Choices: DVD, AUX
A)INPUT ASSIGNMENT 3/4
COMPONENT
.
(1);;;;;
(2);;;;;
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
• Select COMPOSITE (3) to assign components to the
DVD/AUX VIDEO IN jack of this unit.
Choices: AUX, DVD
A)INPUT ASSIGNMENT 4/4
COMPOSITE
.
(3);;;;;
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
INPUT MODE (Input mode)
Use to designate the input mode for the input sources
connected to the DIGITAL INPUT jacks when you turn on
the power of this unit. For information on the types of
audio signals that can be output by this unit, see "Surround
modes and recommended sources" on page 44.
Choices: AUTO, LAST
B)INPUT MODE
p
AUTO
p
[ ]/[ ]:Select
[ENTER]:Return
• Select AUTO to allow this unit to automatically detect
the type of input signal and select the appropriate input
mode.
• Select LAST to set this unit to automatically select the
last input mode used for that input source. If the type of
input signal is different from the setting, no sounds will
be produced.
TV
( TV )
DVD
( DVD )
p
AUX
( AUX )
p
LAST
INPUT TRIM (Input trim)
Use to adjust the input level of the input source.
C)INPUT TRIM
. TV
VCR
AUX
DVD
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
• Select TV ANALOG to adjust the level of audio and
video signals input at the TV/STB analog audio input
jacks of this unit.
Control range: –6.0 dB to 0.0 dB
Initial setting: –3.0 dB
• Select TV OPTICAL to adjust the level of audio and
video signals input at the TV OPTICAL IN jack of this
unit.
Control range: –6.0 dB to 0.0 dB
Initial setting: –3.0 dB
• Select VCR ANALOG to adjust the level of audio and
video signals input at the VCR analog audio input
jacks of this unit.
Control range: –6.0 dB to 0.0 dB
Initial setting: –3.0 dB
• Select AUX OPTICAL to adjust the level of audio and
video signals input at the AUX OPTICAL IN jack of
this unit.
Control range: –6.0 dB to 0.0 dB
Initial setting: –3.0 dB
• Select DVD COAXIAL to adjust the level of audio and
video signals input at the COAXIAL IN jack of this
unit.
Control range: –6.0 dB to 0.0 dB
Initial setting: –3.0 dB
MANUAL SETUP
ANALOG;;;-3.0dB
OPTICAL;;-3.0dB
ANALOG;;;-3.0dB
COAXIAL;;-3.0dB
COAXIAL;;-3.0dB
p
69
En