Troubleshooting - Breville Juice Fountain Duo Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

POSSIBLE PROBLEM
Machine will not work
when switched "ON"
Motor appears to
stall when juicing
Excess pulp building up in
the mesh of the Nutri Disc™
Pulp too wet and reduced
extracted juice
20
EASY SOLUTION
The safety locking arm may not be correctly engaged in the vertical
operating position with the locking arm located into the two grooves on
either side of the juice cover.
Check the Overload Protection Button on the bottom of the motor base
to ensure the safety device has not been activated or the overheating
protection device has not been activated automatically, if it has, allow
more time for the motor to cool down.
Wet pulp can build up under the cover if the juicing action is too
vigorous. Try a slower juicing action by pushing the food pusher down
slower. Clean the Filter bowl surround, the Nutri Disc™ and the juicer
cover. Select a faster speed for harder fruits and vegetables.
The Breville juicer will automatically stop operating if the motor is
stalled. This is a electronic safety feature. Either too much food is being
processed at one time or the pieces are not small enough. Try trimming
food, cutting food into smaller pieces of even size and/or processing
a smaller amount per batch. If this occurs, the light surrounding the
START | STOP button will flash red. To continue juicing, reset the Juicer
by pressing the START | STOP button to OFF, then clear the feed chute,
finally turn the appliance back on by pressing the START | STOP button
to ON.
Hard fruits and vegetables will put excess strain onto the motor if a
low speed is selected. Please refer to the juicing guide, to determine the
correct speed for the fruits and vegetables selected on juicing.
Stop the juicing process. Remove the juicer cover and remove the pulp.
Re-assemble and begin juicing again. Try alternating (soft and hard)
vegetable and fruit varieties.
Try a slower juicing action. Remove Nutri Disc™ and thoroughly clean
mesh walls with the brush included. Rinse Nutri Disc™ under hot
water. If the mesh holes are blocked, soak the Nutri Disc™ in a solution
of hot water with 10% lemon juice to unblock the holes or wash in
the dishwasher. This will remove excess fiber build up (from fruit or
vegetables) which could be inhibiting the juice flow.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Bje820xl

Table des Matières