Troubleshooting - Breville the Juice Fountain Cold Plus BJE530BSS1BUS1 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

Juicer will not work
when switched ON
Overheating with
excessive loads
Excess pulp building
up in the stainless
steel filter basket
Pulp too wet
and reduced
extracted juice
Juice leaks between
the rim of the juicer
and the juicer cover
Juice sprays out
from spout
The safety locking arm may not be correctly engaged in the vertical
operating position. Check the top cover is properly aligned and the
locking arm is located firmly into the two grooves on either side of
the juicer cover.
Motor overload protection may have operated (see below).
The juicer is equipped with an internal self-resetting overload to prevent
the motor from damage under heavy or continuous loads. If the motor
suddenly stops working, turn the dial to OFF, and unplug the unit from
the power outlet. Allow the juicer to cool for at least 30 minutes before
operating again.
NOTE: The unit MUST be turned off in order for it to cool and be reset.
Despite this overload protector, we suggest juicing in smaller batches,
without excessive pushing force, to avoid overheating and stalling and
to maintain the life of the motor.
Stop juicing, disassemble to scoop excess pulp off the juicer cover.
Reassemble and continue juicing. Alternating soft and hard ingredients
may help avoid this.
The cleaner the filter, the better the juice yield, and dryer the pulp. Be sure
to thoroughly clean the juicer as soon as possible after each use. Remove
the stainless steel filter basket and thoroughly clean mesh walls with a
cleaning brush. Rinse the filter basket under hot water. If the fine mesh
holes are blocked, soak the basket in a solution of hot water with 10%
lemon juice to unblock the holes or wash in the dishwasher (top shelf).
This will remove excess fiber build up which could be inhibiting the flow.
Try a slower juicing speed (if possible) and push the food pusher down
the feed chute more slowly.
The juice is being extracted too High; try a slower juicing speed
(if possible) and push the food pusher down the feed chute more slowly.
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

The juice fountain cold plus bje530bss1bca1

Table des Matières