Publicité
Les langues disponibles
Les langues disponibles
EN
The material runs or forms ridges
on the surface.
The material does not cover the
surface very well.
The spray pattern varies a lot
during the work.
It is not possible to press the
trigger on the spray gun.
The flow from the spray gun
does not stop when the trigger is
released.
Material runs out at the pressure
control knob.
Material runs out through the
outlet hose.
The motor overheats and
runs intermittently. The motor
switches off automatically when
overheated. The product can be
damaged if the reason for the
overheating is not rectified.
56
The layer of material is too
thick.
The material is too thin.
The pressure control is worn,
which causes the pressure
to vary.
The trigger lock is applied.
The spray gun is worn.
The pressure control is worn.
Pressure is too high in the
product.
The ventilation openings in
the casing are blocked, or the
product has been covered
over.
The extension cord is too thin
or too long.
Supply voltage too high.
Defective motor.
Move the spray gun quicker.
Use a nozzle insert with a
smaller opening or wider
spray pattern.
Make sure to hold the spray
gun 30 cm from the surface.
Move the spray gun more
slowly.
Use a nozzle insert with
a larger opening or more
compact spray pattern.
Make sure to hold the spray
gun 30 cm from the surface.
Contact an authorised service
centre.
Turn the trigger lock to
release it.
Replace the spray gun.
Contact an authorised service
centre.
Contact an authorised service
centre.
Keep the ventilation openings
clean and do not cover the
product.
Use a suitable extension cord.
Check that the voltage
corresponds to the rated
voltage on the type plate.
Contact an authorised service
centre.
Publicité
