Publicité
Les langues disponibles
Les langues disponibles
before spraying.
MAINTENANCE
Follow the maintenance instructions for best
functionality and useful life.
•
Check and clean the inlet filter and spray
gun filter before use.
•
Replace the filters if they are damaged or
if they cannot be cleaned.
•
Check the product for leakage, especially
at the connections. Replace any damaged
parts.
•
Always check the high-pressure hose for
damage before use. Damaged hoses and
connections must be replaced – never
attempt to repair them.
•
Clean nozzle inserts with a brush and a
suitable cleaner fluid after use.
•
Nozzle inserts may need to be replaced
after 57 to 277 litres of material has been
sprayed, depending on the abrasive
properties of the material.
CLEANING
1.
Carry out steps 1 to 3 in the instructions
for pressure relief.
2.
Turn the nozzle insert to the cleaning
position. Press the spray gun firmly
against an earthed material container
and point it down into the container.
Release the trigger lock and press the
trigger to return the material in the high-
pressure hose to the material container.
3.
When the pressure has been relieved,
release the trigger and apply the trigger
lock.
4.
Lift up the suction hose (10) and outlet
hose (11) and let them run out into the
material container.
5.
Release the outlet hose (11) from the
suction hose (10) and put the outlet hose
(11) in an empty, earthed container.
6.
Sink the end of the suction hose (10)
in an earthed container containing
cleaner fluid. Flush out water-based
paint with water and oil-based paint
and preservative with white spirit or the
equivalent.
7.
Turn the pressure control knob (8)
clockwise to 1/3 of the maximum setting.
8.
Check that the pressure relief valve lever
(6) is in its vertical position.
9.
Put the switch (1) in the on position.
10. Wait until clean water or clean cleaner
fluid comes out from the outlet hose (11).
11. Put the pressure relief valve lever (6) in its
horizontal position.
12. Turn the pressure control knob (8) to 1/2
of the maximum setting.
13. Turn the nozzle insert to the cleaning
position. Press the spray gun firmly
against an earthed container and point
it down into the container. Release the
trigger lock and press the trigger.
14. Wait until clean water or clean cleaner
fluid comes out. Release the trigger and
apply the trigger lock.
15. Release the pressure.
Cleaning the spray gun and filter
1.
Release the pressure.
2.
Unscrew the handle on the spray gun.
3.
Remove the filter from the spray gun and
clean it with a brush and water, or cleaner
fluid. Replace the filter if it is damaged.
4.
Remove the nozzle guard and clean it with
a brush and water, or cleaner fluid.
5.
Replace the nozzle guard in accordance
with the instructions for fitting the nozzle
insert.
6.
Clean the outside of the spray gun with
EN
51
Publicité
