Publicité
Les langues disponibles
Les langues disponibles
Pressure relief valve
The product is supplied with pressure when the
pressure relief valve lever is horizontal. Pressure
is relieved in vertical position and air can be
released. The pressure relief valve is mainly
used to bleed the system before starting the
product. It also protects from overflowing if
there is overpressure in the product.
FIG. 4
Manual valve
If the product has not been used for some
time the ball in the inlet valve can fasten to the
valve seat, which will prevent feeding of the
paint. Press the manual valve lever repeatedly
to release the inlet valve ball so that the inlet
valve can work as usual.
FIG. 5
Pressure control valve
The pressure control valve has a sensor that
detects the pressure in the pump housing
and sends a signal to the control card, which
regulates the pressure.
Outlet and inlet valves
The outlet and inlet valves are controlled
together to keep the paint under pressure and
to supply the high pressure for spraying.
ASSEMBLY
UNPACKING
Unpack the product and check that all the
parts are included and undamaged. Check
before use that all screw unions and other
joints are properly tightened.
WARNING!
Do not use the product if parts are missing
or damaged – risk of bursting that can cause
serious personal injury and/or material
damage.
1.
Connect the high-pressure hose (12) to
the fluid outlet (3) and firmly tighten with
a spanner. Connect the other end of the
high-pressure hose (12) to the spray gun
(13) and firmly tighten with two spanners.
Check that the trigger lock is applied.
2.
Check that the nozzle insert is correctly
inserted in the nozzle guard and that
the nozzle guard is firmly mounted on
the spray gun. See section "Assembly of
nozzle insert".
3.
Release the pressure. See section
"Pressure relief".
ASSEMBLY OF NOZZLE INSERT
1.
If the spray gun is not connected to the
product, go to step 2. If the spray gun
is connected to the product, release the
pressure.
2.
Apply the trigger lock.
3.
Fit the nozzle guard parts (2) in the order
shown in the figure.
–
Fit the rubber gasket (5) and metal
seal (4) in the nozzle guard (2) by
using the nozzle insert (1).
–
The nozzle insert (1) should be
inserted all the way in the nozzle
guard (2). Turn the nozzle guard (1)
and press down at the same time.
–
Turn the arrow shaped handle on the
nozzle insert (1) forward to the
spraying position.
4.
Fit the nozzle insert (1) with the nozzle
guard (2) on the spray gun and tighten
the lock nut (3).
FIG. 6
EN
47
Publicité
