Meec tools 011485 Mode D'emploi page 55

Too little or no flow of material,
or it is not possible to achieve an
acceptable spray pattern.
The product does not maintain
the pressure.
Not enough material.
The suction hose is blocked.
The nozzle insert is in the
cleaning position.
The nozzle insert is blocked.
The spray gun filter is
blocked.
The material is too thick.
The nozzle insert is too big for
the actual job.
The nozzle insert is worn.
The seal and gasket on the
nozzle insert are worn or
missing.
The inlet filter is blocked.
The inlet or outlet valve is
blocked.
Pressure set too low.
The high-pressure hose is too
long.
Leakage.
The seal is worn.
The inlet or outlet valve is
worn.
The nozzle insert is worn or
too big for the actual job.
Check that the end of the
suction hose is under the
surface in the material
container.
Follow the instructions for
clearing a blockage.
Turn the nozzle insert to the
spraying position.
Clean the nozzle insert.
Clean the spray gun and filter.
Dilute the material in
accordance with the
instructions of the material
manufacturer.
Choose another nozzle insert.
See the table for nozzle
inserts.
Replace the nozzle insert.
Replace the metal seal and
gasket.
Clean the inlet filter.
Clear the valves.
Turn the pressure control
knob clockwise to set a higher
pressure.
Use a suitable high-pressure
hose.
Relieve the pressure and
tighten all the connections.
Replace seal.
Contact an authorised service
centre.
Replace the nozzle insert.
EN
55