Track Cleaning - LGB 21670 Mode D'emploi

• Do not use to clean the nickel plated LGB rails.
• The cleaning motor operates only when the 21670 is
moving forward. This makes it easy to clean dead-end
sections, like sidings.
• The 21670 will not clean wet or oily rails.
• Track Cleaning Wheels (67267) are available from
authorized LGB retailers. The package includes cleaning
rings, inner wheel flanges and outer wheel discs. Always
replace the flanges and disks together with the cleaning
rings.
Attention! When cleaning the tracks, carbon dust and other
debris accumulates around the track. This dust and debris
can stain carpet and other materials.
14

Track Cleaning

Analog operation (conventional transformer and throttle):
• Set your layout speed control to zero.
• Place the 21670 on the track.
• Set the power control switch to Position 2 (see Operating
Modes).
• Set the 21670 on-board speed control to a middle position
(Fig. 4).
• Set your layout speed control to the highest forward
position.
The 21670 will move forward with a medium speed, and the
cleaning wheels will clean the rails.
Hint:
• The speed of the track cleaning loco is adjusted with
the on-board speed control. The layout speed control
(Fig. 4) always should be set to the highest speed, so the
cleaning wheels are turning at maximum speed.