Safety Notes; Important Notes; Functions - LGB 21670 Mode D'emploi

Safety Notes

• This model may only be used with the operating system
designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC
systems with conventional LGB DC train controllers or
power packs (DC, 0 - 24 volts).
• This model comes from the factory with a built-in multi-
train system decoder (multi-train system).
• For operation with the Multi-Train System, the model is
programmed to loco address 03.
Note: Use a locomotive controller with more than 2 amp of
train current for this model.
10
This model is equipped with standard LGB couplers on the
front and rear.
Mode of Operation Switch
There is a three-way power control switch mounted in the
cab (Fig. 1&2). The switch can be reached through the open
window:
Pos. 0 All power off
Pos. 1 Drive motor and light on. Cleaning motor off.
Pos. 2 Drive motor and light on. Cleaning motor ready.
Back-EMF
The loco features a "Back-EMF" function, which works both
with analog control and with the Multi-Train System.
Hint: This feature does not work at top speed, because
additional voltage must be available to overcome any added
load.