Publicité
Les langues disponibles
Les langues disponibles
Venting
1. Take the plug out of the socket.
2. Open the hot water tap and wait until it flows from a tap.
3. Set the temperature regulation knob at desired position.
4. Put the plug into a socket.
Temperature control
Safety valve must regularly opened in order to remove deposit and ensure it is not
blocked. To perform this maintenance, check, if the safety valve works properly: turn
the lever or the turning knob of the valve to open the water outflow from the outlet
pipe. If there is no water outflow, the valve is faulty and the water heater cannot be
operated. (refers to water heater in a pressure assembly to the water mains).
PL;DE;FR;GB-029B_f.753
On the front part of the heater casing there
is a knob intended for temperature setting.
The knob set as on the figure (anticlockwise)
indicates the ‚switch off' position. Water tem-
perature setting should be chosen smoothly
from „ " (~7
C) position to „
0
When the diode (indicating ‚heating') is on, it
means water is being heated.
If the appliance is mounted in a place where
temperature drops below 0
totally empty the heater out of water:
-
over-the-sink version (POC.G end POC.
Gb) - dismount connecting tube from
the inlet fitting (cold water); open the hot
water tap,
-
under-the-sink version (POC.D) - un-
screw flexible connectors (hoses) from
the inlet and outlet fittings (hot and cold
water), remove the heater from the wall
(hooks) and turn it 180
GB
"or „III"(~70
C).
0
○○○
C, you should
0
round.
0
21
Publicité
