Publicité
Les langues disponibles
Les langues disponibles
Installation/ Assembly work
PL;DE;FR;GB-029B_f.753
1. Mount the heater on the wall in vertical position
according to two options given below:
a) fix two (stretching) pins ø 8 into the wall with a
140 mm-distance between them,
-
screw the fixing screws in such a way that there
will be no more than a 4 mm-slot between a wall
and a screw head,
-
hang the heater on the fixed screws,
b) fix the special hanger to the wall and hang the
heater. In case of assembly of the POC.Gb, a
spacing between axes of fixing pins and the tap
has to be kept.
2. According to figure bring the supply water to
the point where the heater is to be mounted.
In the heater:
a) POC.G or POC.D connect cold water to the
inlet fitting according to figure and hot water
outlet to the outlet fitting. On the cold water
inlet supply pipe a mandatory safety valve [6]
has to be installed with a rated pressure of 0,6
MPa.
b) POC.Gb connect the heater to the tap (with
metal tubes or flexible connectors (hoses) -
placing gaskets on the nuts beforehand. The
recommended distance between the axis of the
tube and the wall is 34mm.
3. After connecting the heater to hydraulic system,
open the hot water tap (red colour) and wait
until the inner tank is filled with water (when
water starts running from the tap).
4. Check connections for their tightness.
GB
19
Publicité
