Maintenance /Cleaning; Fault Finding; Storage And Transportation; List Of Parts - PLYMOVENT PERSONAL PRO Mode D'emploi

6.3.2. Battery changing:
Removing the battery: Locate the battery catch. Pull back the battery catch and at the same time the Battery
can be removed by lifting upwards.
Fitting the battery: Make sure the battery is the correct way up (as per 5.2) and then slide into the bower until
the battery catch engages. It is essential that the battery catch is fully locked.
7. Maintenance / Cleaning:
The Blower unit, filler housing and head units must ail be regularly cleaned to keep them in good working
order.
For single users, the units can all be cleaned with a cloth moistened with luke warm water and soap.
For multiple users, the units should be disinfected when passed from one user to another.
The Manufacturer recommends that 'Incidur' from Ecolad GmbH & Co. OHG is used for disinfecting.
Liquids must not be allowed to enter the workings of the blower unit or get on to the element of the filter.
Parts should be allowed to air dry. Under no circumstances should any solvents or abrasive cleaning agents
be used.The unit must not be dried using hot air or radiant heat.
The unit should continue to provide protection to the designed specification for 2 to 3 years, when maintained
in accordance with these instructions. Prior to each use the user should check that the unit is free from
defects, such as cracks, split filters and hoses, cracked visors and helmet components as appropriate

8. Fault finding :

If there is a sudden change in air supply while using the PersonalPro system, it is necessary to check the
following:
That all parts of the air-supply system are assembled properly.
The battery and its connector.
Whether the charger is not faulty or malfunctioning (if so, diodes do not work).
Filters and their clogging.
That there is not a hole in the air hose.
Whether the hood seal is not damaged.
Whether the working time after a full recharging of the battery has not decreased (if so, it is necessary to
replace the battery).

9. Storage and Transportation:

When not in use or during transportation the blower and head units should be stored in the
container in which they were provided, or other similar container, such that it is out of direct sunlight,
not in contact with solvents and cannot be damaged by physical contact with hard suriaces/items.
Do not store outside the temperature range of +O°C to +40°C or with humidity or with humidity above
75%RH

10. List of parts

10. List of parts 10. List of parts 10. List of parts
1
2
3
4
4
4
5
5
6
7
8
9
9
Face seal
Head Gear and Air Duct Assembly
Hose and Cover Assembly
Belt
Belt extension
Harness
Euro Charger
Universal Charger
Battery
Blower Unit
Filter
Pre Filter
Carbon pre filter
0000105016
0000105015
0000105012
0000105023
0000105004
0000105005
-
0000105014
0000105013
-
0000105010
0000105011
0000105003