Security Functions - Lindy 32828 Manuel

English Manual
Factory Default Settings
The factory default settings are as follows:
Setting
Display
Duration
Display Mode
Scan Duration

Security Functions

OSD Security
In order to prevent unauthorized access to the computers, the OSD provides a password
security feature. If a password has been set, the OSD will request that the user specifies it
before allowing entry.
Password:
To set a password:
1. Highlight this item, then press [Enter].
The password may be up to 8 characters long, and can consist of any combination of
letters and numbers (A - Z, 0 - 9).
Key in the new password, then press [Enter].
Key in the new password again, in order to confirm that it is correct then press [Enter].
If the two entries match, the new password is accepted and the screen displays the
following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start this procedure again.
Note: To modify or delete a previous password, access the Password function as in Step 1,
above, then use the backspace or delete key to erase the individual letters or numbers.
Default
Always On
The Port Number plus the Port Name
3 Seconds
14