AERMEC MGH R410A Manuel D'installation page 8

How to fix installation plate
The wall you select should be strong
and solid enough to prevent vibration
1. Mount the installation plate on the
wall with 6 type "A" screws. If
mounting the unit on a concrete
wall, use anchor bolts.
Mount the installation plate horizontally
by aligning the centerline using a level.
Installation Plate
Type "A" screw
2. Measure the wall and mark the
centerline. It is also important
to use caution concerning the
location of the installation
plate-routing of the wiring to
power outlets is through the
walls typically. Drilling the hole
through the wall for piping
connections must be done
safely.
C
Installation plate
Ø70mm
Left rear piping
Distance (mm)
CHASSIS
(Grade)
A
SQ, SW 75
SR 0
ST 105
A
Ø70mm
Right rear piping
B C D
12 80 12
40 20 40
0 210 0
5
Drill a hole in the wall
Drill the piping hole with a ø70mm hole
core drill. Drill the piping hole at either
the right or the left with the hole slightly
slanted to the outdoor side.
WALL
Indoor Outdoor