SMA SUNNY TRIPOWER STORAGE 60 Instructions D'installation page 26

5 Installation
Figure 13: Mounting the wall mounting bracket
1. Mark the position of the drill holes using the wall
mounting bracket. Use at least one hole on the right
side of the wall mounting bracket and one on the left.
2. Drill the holes and insert the screw anchors.
3. Secure the wall mounting bracket horizontally to the
wall using screws and washers.
5.4 Mounting the Inverter
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or
dropped while being transported or mounted.
• Transport and lift the product carefully. Take the
weight of the product into account.
• Wear suitable personal protective equipment for all
work on the product.
Requirement:
• The wall mounting bracket must be mounted.
Procedure:
1. Attach M12 eyebolts and matching nuts to the inverter
(not included in the scope of delivery).
2. Lift the inverter.
26 STPS60-IA-xx-13
Figure 14: Attach the eye bolts and lift the inverter
3. Locate the slots on the side of the wall mounting
bracket.
4. On the inverter, position the side screws against the
wall mounting bracket slots. Push the inverter so the
side screws slide into the two lower slots and the two
upper slots.
Figure 15: Hook the inverter into the wall mounting bracket
5. Ensure that the four side screws sit securely in the wall
mounting bracket slots.
6. Remove eyebolts and keep for disassembly.
SMA Solar Technology AG
Installation Manual