Publicité
Les langues disponibles
Les langues disponibles
Pull down the terminal box cover.
Remove the control section.
Attach the wall support.
Connect either a 2-wire telephone cable or an electrical cable
with a cross-section of up to 2 x 1.5 mm² to the 2-pin connector.
The wires can be interchanged.
Reassemble the control section, performing the same
operations as for disassembly in reverse order.
2
Choose the position
00N036B
Attaching the wall support and electrical connection
The remote control will be installed against an internal partition, about
1.5 m from the floor in a judiciously choosen "reference" room.
Enclosed, exposed to solar radiation, heated by a flue duct, exposed
to cold or hot air currents from air ducts, close to an open fireplace, a
heat source (television), behind a curtain.
RS 100
Positions to be avoided
19/07/07 - 300010276-001-A
Publicité
