MX-PG PG 3010F Manuel D'instructions page 25

10. TROUBLESHOOTING
Troubleshooting
Problem
Motor does not start
Motor is noisy and irregular.
No electrical output.
Motor does not stop.
11. REPAIR
Only use accessory and replacement parts
recommended by the manufacturer. If the
appliance should fail in spite of our quality control
and your care, have it repaired by an authorized
technician only.
12. ENVIRONMENTAL PROTECTION
Do not simply dispose of the appliance, its
accessories and packaging into the household
waste, but recycle it instead. This small effort helps
our environment.
All manuals and user guides at all-guides.com
Cause
No fuel in the tank.
Fuel valve closed.
Motor oil level too low (oil warning lamp
is flickering).
On/Off switch for motor operation in
wrong position
Dirty ignition plug.
Dirty air filter.
Dirty ignition plug.
Dirty air filter.
Fuel contaminated/old
Choke switched to „CHOKE" Wrong fuel,
e.g. diesel instead of petrol.
Overload protection switch in the AC
power generator released.
Ignition switch-off wire damaged.
Solution
Fill the tank with fresh fuel.
Turn the fuel valve to „ON".
Refill motor oil.
Switch to the right position.
Clean/replace the ignition
plug.
Clean/replace the air filter.
Clean/replace the ignition
plug.
Clean/replace the air filter.
Replace the fuel.
Turn choke switch to "RUN"
Replace the fuel with the
correct one.
Reactivate the protection
switch.
Contact a service centre
responsible for warranty
cases.
Close the fuel valve and
wait for the motor to switch
off.
5