MX-PG PG 3010F Manuel D'instructions page 20

6. TO START THE MOTOR
NOTE: Check prior to operating the generator.
Recommended fuel: unleaded petrol, at least 90
octane.
 Do not connect electric appliances before
starting the motor..
 Switch the fuel valve to "ON".
 Switch the choke to position "CLOSED"
 Switch the motor switch to position "ON".
 Slowly pull the reversing starter until you feel
resistance. Now pull with force.
Widerstand spürbar. Dann kräftig ziehen.
 Switch the choke back to position "OPEN" while
the motor is warming up..
wARNING: Take care not to injure your fingers.
If the motor does not start and the piston is not
raised completely, the starter handle might be
suddenly pulled back.
Avoid the starter handle crashing against the
motor. Slowly move it back with your hand so
as to avoid damaging the cover.
0
All manuals and user guides at all-guides.com
7. CONNECTION
7.1. CONNECTABLE ELECTRIC APPLIANCES
This power generator can supply the power for
bulbs, heaters, drilling machines, water pumps, etc.
Do not exceed the maximum load of the
generator.
The power generator must not be used as
power source for appliances with high power
consumption.
The power generator cannot be used as a power
source for high precision appliances such as
computers.
Such precision appliances might be damaged
because of distortion during power supply.
Do not connect the power generator to the
electrical installation of a building.
wARNING: The connection to the electrical
installation of a building might result in the
back-transfer of electrical power into the mains
supply. This back-transfer means the risk of
a lethal electric shock for technicians of the
power supply company or other persons who
come into contact with the conductor during a
power blackout.
The connection to the electrical installation
of a building might also result in the back-
transfer of the electrical power from the mains
supply to the power generator. when the mains
supply resumes power, the power generator
can explode, burn or cause fire in the building's
electrical installation.