GYS STARTPACK PRO 12.24 XL Manuel D'utilisation page 69

• Avoid flames and sparks. Do not smoke near the device.
• Protect the battery's electrical contact surfaces against short-
circuits.
Risk of acid dispersion!
• Wear protective goggles and gloves.
• In case of contact with the eyes or the skin, rinse with water imme-
diately and seek medical attention as soon as possible.
Connection / disconnection :
• Ensure that the charger's power supply is disconnected before
plugging or unplugging the connections on the STARTPACK 12.24
XL.
• Connect the GYSFLASH 6.12 XL to the STARTPACK 12.24 XL.
The charger must be connected to the mains.
•After charging, disconnect the charger from the mains, then
disconnect the charger's connections from the STARTPACK 12.24
XL.
Connection :
• Class II device
• The connection to the power supply must be carried out in
compliance with national standards..
Maintenance :
• If the power cable is damaged, it must be replaced by the
manufacturer (GYS' dedicated sales service) or by an equally
qualified person to prevent any accidents.
• Maintenance should only be carried out by a qualified person.
• Warning ! Always disconnect from the mains before performing
maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the manufacturer
(GYS' dedicated sales service) or by an equally qualified person to
prevent any accidents.
• Do not use solvents or any agressive cleaning products.
• Clean the device's surfaces with a dry cloth.
Regulations :
• The machine compliant with European directives
• EAC Conformity marking (Eurasian Economic Community)
GYSFLASH 6.12 XL EN
9