GYS STARTPACK PRO 12.24 XL Manuel D'utilisation page 15

USE IN CHARGER MODE (CHARGE INTERNAL BATTERIES)
For the STARTPACK PRO 12.24 XL to be always operational and deliver maximum starting power, it is recommended to
charge it after each use and to keep on charge until next used.
The STARTPACK PRO 12.24 XL is fitted with an autonomous charger which charges and maintains the internal batteries
at 100% and without the need for monitoring (Floating System).
i
For further details about the charge, see the GYSFLASH 6.12 XL instruction manual.
INTERNAL BATTERIES : RECOMMENDATIONS AND MAINTENANCE
These high performance batteries require the user to be extra careful. Observing the following recommendations will
lenghthen the batteries' lifetime.
• Charge the machine after each use.
• Do not use an external charger other than the one supplied with the machine.
• Set the voltage selector on 12V during the charge.
• Never connect the red clamp to a battery's negative terminnal and the black clamp (-) on the engine. This would short
circuit the STARTPACK PRO 12.24 XL's batteries.
• Wait 3 minutes before each start attempt. This allows the device to cool down and the batteries' voltage to recover. Not
waiting long enough between each attempt reduces the chances of a succesful start at the next attempt (power loss).
STARTPACK PRO 12.24 XL
• Put the voltage selector on 12V.
• Connect the GYSFLASH 6.12 XL cable to the STARTPACK PRO 12.24 XL.
• Connect the GYSFLASH 6.12 XL to a 230V 50/60Hz mains socket.
• The charge starts automatically.
• The STARTPACK PRO 12.24 XL displays the state of charge :
- Red indicator : the batteries are damaged ;
- Orange indicator : the batteries are charging;
- Green indicator : the batteries are charged.
• After the charge, keep the machine connected to the mains.
EN
15