Please Read Immediately; Legal Regulations And Directives; Required Tools; Scope Of Supply - Dimplex WWSP 885S Instructions De Montage Et D'utilisation

1
1 Please read
immediately
ATTENTION!
Work on the domestic hot water cylinder must only be performed by
qualified personnel.
ATTENTION!
This device is only intended for use as specified by the manufacturer.
Any other use beyond that intended by the manufacturer is prohibited.
This means that the user must also observe all relevant product
information. Tampering with or altering the device is not permitted.
1.1 Legal regulations and
directives
ATTENTION!
Assembly is to be adapted to the on-site conditions and implemented in
accordance with recognised codes of practice. Local regulations are to
be observed in this regard.
The following codes of practice are to be
considered in particular:
DIN 1988 P1-8

Codes of practice for drinking water installations
 DIN 4753
Water heaters, water heating installations and storage water
heaters for drinking water
 DIN 4751
Safety equipment for heating installations
 DIN 18380
Installation of central heating systems and hot water supply
systems
 DIN 18381
Installation of gas, water and drainage pipework inside
buildings
 DIN 4757 P1-4
Solar heating plants / solar thermal installations
 VDE 0100
Erection of electrical equipment
 VDE 0105
Operation of electrical installations
 VDE 0190
Equipotential bonding of electrical installations
 DIN 18382
Electric cable and wiring systems in buildings
GB-2

1.2 Required tools

 Flat grips / pipe wrench
 Open-ended spanner for hydraulic fittings
 Screwdriver, Phillips head / slotted head
 Transport tool
 Installation tool for water and heating connection

1.3 Scope of supply

 Domestic hot water cylinder, 800 litres
 2-piece polyester insulation for domestic hot water cylinder,
complete with cover and flange cover
 Correx anode kit for 2 impressed current anodes, complete
with power supply unit and operating instructions
 Installation and operating instructions (supplied with the cyl-
inder and insulation)
 NTC-2M and NTC-10M sensor in a polybag with supple-
mentary sheet supplied with the cylinder
 Wiring diagram label and type plate supplied with the cylin-
der for subsequent mounting on the cylinder insulation

1.4 Supplementary materials

 Sealing material (hemp or other similar substance)
 Installation material for the water and heating connection
(transitions, fittings, T-pieces, etc.)