Ribimex PRTRB12V Manuel D'instructions Et D'utilisation page 18

• Adjust the chain tension.
• Restore the chain sprocket cover onto the tool, then turn the wingnut clockwise to secure the
cover.
Tensioning the saw chain
• Check the chain tension regularly during operation and re-adjust, if necessary.
• Switch off the tool and remove the battery.
• Turn the wingnut (4) by two turns anti-clockwise.
• Move the guide bar to the left or right until the drive links are half inserted into the groove at
the underside of the guide bar. See Fig. 7.
• Tighten the wingnet by hand to secure the chain sprocket cover.
Lubricating the saw chain and guide bar
• Switch off the tool and remove the battery.
• Rest the tool on a level surface with the sprocket cover facing up.
• Clean the guide bar and saw chain with a soft brush.
• Apply multifunctional oil in lubricating area between guide bar and saw chain. See Fig. 8.
• Install the battery.
• Switch on the tool for 10s, allow the oil dispersed on the saw chain.
Chasse Pêche
Fig. 6
Fig. 7
Fig. 8
Loisir et nature
Page 18 / 33
www.ducatillon.com
Jardin Élevage