Operation - Haussmann Xpert MJ10250IIIA Guide De L'utilisateur

3
1
120V
L1
3
1
240V
L1
fig.41
- Wiring Schematic
Paddle
Key
Switch
fig.42
- ON/OFF Switch
INSTALLATION
ELECTRICAL CONNECTIONS
2
WARNING: Make sure unit is off and disconnected from power source before
inspecting any wiring. The saw is prewired for use on a 120 volt, 60HZ power
4
supply. The power lines are inserted directly onto the switch. The green ground
line must remain securely fastened to the frame to properly protect against electrical
shock.
L2
240 VOLT OPERATION
2
• To use the saw with a 240V, single-phase power supply, have a qualified
electrician attach a 240 volt, 15A 3-prong plug onto saw line cord and install
4 the proper connectors and receptacles to power supply.
• See wiring diagram (Figure 41) for wiring instructions.
L2

OPERATION

Refer to Figures 42-51,
DESCRIPTION
The 10" Table saw offers precise cutting performance for all woods up to
3-1/8" thick. The saw is designed for the professional user and is ruggedly
constructed for continuous service. The 10" saw is recommended for use with a 10"
blade.
The saw features an extra large cast iron table. Saw body has on board storage
for push stick, mitre gauge, rip fence and saw blades. Saw is equipped with a riving
knife and a clear acrylic blade guard with anti-kickback feature. Cabinet is
constructed of heavy gauge welded steel, totally enclosed and is ported for a 4"
vacuum hose.
Rip Fence Assembly features a heavy-duty precision rip fence that is designed for
simple and one-hand maneuverability. Front rail is calibrated in inches and millimeters
with a magnified window for close tolerances.
WARNING: Disconnect power before attempting any of the following procedures.
Be certain switch is in OFF position and safety disconnect (or breaker) is in OFF
or open position. Saw blade must not be moving. Saw blade will rotate freely after
motor is turned off. Allow blade to come to a complete stop before attempting any
of the following procedures.
WARNING: The operation of any power tool can result in foreign objects being
thrown into the eyes, which can result in severe eye damage. Always wear safety
goggles complying with United States ANSI Z87.1 before commencing power tool
operation.
STARTING AND STOPPING THE SAW
Refer to Figure 42.
WARNING: Never operate saw without blade guards in place. Be sure blade is
not in contact with workpiece when motor is started. Start motor and allow saw
to come to full speed.
WARNING: Make sure the electrical characteristics of motor nameplate and
power source are the same.
• The ON/OFF switch is located under the front rail of the table saw at the left
side.
• To turn saw on, stand to either side of the blade—never in line with it. Raise large
red OFF paddle and pull up ON/OFF switch. Always allow saw blade to come up
67