Haussmann Xpert MJ10250IIIA Guide De L'utilisateur page 65

ASSEMBLY
POSITION AND ADJUST RIVING KNIFE
Refer to Figure 31.
• Riving knife is installed on the saw. Raise the blade completely to access the
riving knife.
• Loosen the locking knob and raise the riving knife to its highest position. Riving
knife has three holes for three positions. The highest position is for all through-cuts.
The middle position is for rabbets and other non-through cuts, (with guard and
pawls removed). The lowest position is for dado cuts.
• Make sure locking pin is aligned with riving knife hole and secure in position by
tightening locking knob.
• Riving knife must be in line with blade. Make sure riving knife sits flat against
mounting bracket and lock plate.
RIVING KNIFE TO BLADE ADJUSTMENT
• Riving knife to blade clearance: the gap between the riving knife and the saw
blade should be an even distance across the entire radius.
• The riving knife should also be in line with the saw blade. If adjustment is
necessary:
1. Locate the riving knife bracket.
2. Loosen the two socket head cap screws slightly enough to move the bracket,
bringing the riving knife in line with the saw blade. Make sure the gap between the
blade and knife is even and from 1/4 to 5/16" in distance.
3. Once the riving knife is aligned with the blade, tighten the socket head cap
screws.
INSTALL TABLE INSERT
Refer to Figure 32.
• Make sure that the riving knife is raised to its highest position.
• Place table insert into throat of table.
• Insert is held in position by magnet in table.
• To adjust insert level with table, adjust leveling screws up or down.
ATTACH BLADE GUARD AND ANTI-KICKBACK PAWLS
Refer to Figures 33-36.
• Place the slot of blade guard body over the riving knife. Slot of bushing is placed
in the notch indicated in Figures 33 and 34.
• The bushings have a beveled edge and must be located in the center of the
notch to lock properly.
• Position guard completely down on riving knife and press latch to lock in position.
• Blade guard body should be parallel to the table. If not, adjust the 2 mm set screws
as necessary.
• Place anti-kickback pawl set onto riving knife at notches indicated. The spring pin
is placed in the front notch and bolt is placed in the rear notch.
• Press pawl set completely down and press latch to secure in position.
NOTE: The teeth of anti-kickback pawls should touch table surface. Use set screws
to adjust if needed.
64
Locking
Knob
Plate
fig.31
- Riving Knife
Leveling Screws
fig.32
Pawl Set
Blade Guard
Riving Knife
fig.33 -
Blade Guard and Pawl Attachment
Bushing
Notch
fig.34
Insert Pin Here
Insert Bolt Here
fig.35
- Attach Pawl Assembly
Locking Pin
Screw
Bracket
Pin
Bolt