ASSEMBLY
fig.12
fig.13
fig.14
fig.15
fig.16
60
ATTACH CASTER SETS TO BASE
Refer to Figure 12.
Tools Required: 5 mm Hex Wrench
Hardware Required: Eight M8 x 16 socket pan head screws (Hardware bag #4).
• Attach one caster set to the two front corner supports using four M8 x 16 socket
pan head screws.
• Attach the remaining caster set to the two rear corner supports.
ATTACH CORD WRAP HOOKS
Refer to Figure 13.
Tools Required: 4 mm Hex Wrench
Hardware Required: Two M6 x 16 socket pan head bolts, two M6 flat washers and
two M6 hex nuts (Hardware bag #4).
• Insert a bolt into a cord wrap hook and place against the holes on the left side of
the saw cabinet.
• Secure hook in position using flat washer and hex nut.
• Repeat for other hook.
ATTACH BASE TO CABINET
Refer to Figures 14 and 15.
Tools Required: 8 mm Hex Wrench
Hardware Required: Four M10 x 25 socket head bolts, four M10 lock washers and
four M10 flat washers (Hardware bag #4).
• Place dust chute over the cabinet as shown. Make sure the holes in the corners
are aligned with the slots in the dust chute.
• Place the base assembly over the dust chute and secure the base assembly to
the cabinet using the flat washers, lock washers and bolts.
• Secure all fasteners in the base assembly fully tight.
ATTACH RIP FENCE BRACKETS
Refer to Figure 16.
Tools Required: 5 mm Hex Wrench
Hardware Required: Two M6 x 16 socket head bolts, two M6 flat washers and two
M6 hex nuts (Hardware bag #4).
• Install the rip fence storage brackets to the right side panel of the base using two
bolts, flat washers and hex nuts.