Haussmann Xpert MJ10250IIIA Guide De L'utilisateur page 62

Rubber Feet
Slotted Bracket
Blade Guard
Bracket
Front Side of Saw
Push Stick
Bracket
fig.17
Straight Edge
fig.18
Flange
fig.19
Arbor Lock
fig.20
ASSEMBLY
BLADE GUARD AND PUSH STICK STORAGE BRACKETS
Refer to Figure 17.
Tools Required: Phillips screwdriver and 4 mm hex wrench
Hardware Required: Four M3 x 10 pan head screws, four M3 lock washers, four
M3 flat washers, four M5 x 12 socket head bolts, four M5 lock washers and four
M5 flat washers (Hardware bag #4).
• Install the push stick storage brackets to the left side panel of the base using four
screws, lock washers and flat washers.
• Install the blade guard storage brackets to the left side panel of the base using
four screws, lock washers and flat washers.
NOTE: Attach the slotted bracket to the front side of the saw.
• Press the four rubber feet to the base legs.
• With the aid of an assistant turn the saw upright.
WARNING: To avoid injury, do not attempt to turn saw upright by yourself.
ATTACH TABLE EXTENSIONS
Refer to Figure 18.
Tools Required: 8 mm Hex Wrench and Straight Edge
Hardware Required: Six M10 x 25 socket head bolts, six M10 lock washers
and six M10 flat washers (Hardware bag #1).
• Assemble extension to the table using socket head bolts, lock washers and flat
washers.
• Wipe surface clean.
• Hand tighten only. Do not tighten completely until tables are level. Use a
straight edge to level tables.
• Repeat above procedure for the other extension.
• Use a straight edge to check level and flatness between main table and extensions.
• After tables are adjusted level and flat, secure the extensions by tightening the
bolts completely.
INSTALL BLADE
Refer to Figures 19 and 20.
Tools Required: 13 mm Open-end Wrench
• Loosen knob on right side of cabinet.
Nut
• Remove blade and wrench. Replace knob.
• Raise blade assembly all the way up.
• Depress arbor lock and use wrench to loosen flange nut. Remove flange and nut
from arbor.
• Place blade on arbor. Make sure arrow on blade and teeth point towards front of
saw.
• Replace flange and nut on arbor and securely snug blade in position.
61