Publicité
Les langues disponibles
Les langues disponibles
I NSTAL L AT IO N
Preparation
Before moving the oven, protect any finished flooring and
secure the oven door closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
OVEN D O O R R E M O VA L
To remove, open the oven door completely. Rotate both
hinge latches forward to the open position. Close the door
to the at-rest position, then lift up and out. Refer to the
illustrations below.
To reinstall, insert the door hinges into the frame open-
ings. Open the oven door completely and rotate both hinge
latches back to the closed position.
OPEN
POSITION
CLOSED
POSITION
Oven door hinge latch
Door at-rest position
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Installation
Place the oven in the opening and slide back partially. Guide
the power cord through the opening of the adjacent cabinet
and slide oven back fully. Verify the power cord is not
trapped between the oven and cabinet wall.
Locate the mounting holes on the oven side trim, two on
each side. Drill
1
/
" pilot holes. Use the mounting screws
16
provided to secure the oven to the cabinetry. Refer to the
illustration below.
To avoid interference, a 90° door stop may be required for
any appliance or cabinet door installed next to the oven.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
MOUNTING
HOLES
Oven installation
Troubleshooting
IMPORTANT NOTE:
If the convection steam oven does not
operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the oven.
•
Verify proper electrical connections.
•
If the oven does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
oven. Wolf is not responsible for service required to
correct a faulty installation.
|
wolfappliance.com
5
Publicité
