Backup Operating System; Dc Operation Precautions (3-Way Models Only) - Norcold N41X Mode D'emploi

You can reset the controls and remove this fault code one time. To reset the controls, shut off and then start the refrigerator.
- To turn off the refrigerator, push the ON / OFF button for one second and then release.
- To turn on the refrigerator, push and release the ON / OFF button.
If you reset the controls and the fault occurs again before the refrigerator completes a full cooling cycle:
- The heat sources to the cooling unit are turned off and are locked out.
- A fault code "n" shows in the Center display.
- This time you can not reset the fault. Have the refrigerator serviced by your dealer or a Norcold authorized Service Center as soon
as possible.

Backup operating system:

This refrigerator has a backup operating system. The backup operating system allows the refigerator to continue to cool if the
temperature sensor of the refrigerator should fail.
If this failure occurs:
- The refrigerator automatically changes to the backup operating system.
- When you push the TEMP SET button, the temperature setting flashes in the center display for ten seconds.
- After the temperature setting flashes, the mode of operation appears in the center dispaly.
- The backup operating system can overfreeze or thaw the contents of the freezer and the fresh food compartment.
- Make sure the temperatures of the freezer and the fresh food compartment are satisfactory.
NOTICE
- If the temperature is too warm, push and hold the TEMP SET button to raise the temperature setting by one number.
- If the temperature is too cold, push and hold the TEMP SET button to lower the temperature setting by one number.
- Have the refrigerator serviced by your dealer or an Norcold authorized Service Center as soon as possible.

DC Operation Precautions (3-way models only)

This refrigerator is made to operate on DC power while your vehicle is "in transit" and AC power or propane gas sources are not
available. Operate the refrigerator on DC power only when the vehicle engine is running.
For the refrigerator to operate correctly on DC power, the battery must be maintained in a fully charged condition.
For the battery to be fully charged at all times during refrigerator operation on DC, the vehicle engine must be running and the battery
charging system must be in good operating condition.
Keep in mind the following electrical precautions for DC operation of the refrigerator:
- Good battery condition is necessary for correct DC operation.
- The capacity of the battery charging system must be more than what is necessary for the refrigerator and other DC appliances.
- While the vehicle engine is running, make sure the voltage of the DC power supply leads at the refrigerator is more than 11.5 VDC.
Owner's Manual 8
If you open the door(s) too often, the temperatures inside the freezer and fresh food compartment do not
become stable. Allow the refrigerator to operate for about one hour after each adjustment change before you
examine the contents. The number "9" is the coldest temperature setting.