Removing Air From The Propane Gas Supply Lines - Norcold N3000 Serie Manuel D'installation Et D'utilisation

Control panel with LCD touchscreen ........................................................................................................................................................5
On/off switch ...........................................................................................................................................................................................5a
Touchscreen ...........................................................................................................................................................................................5b
Mode symbols ........................................................................................................................................................................................ 5c
Cooling level indicators...........................................................................................................................................................................5d
Symbol 'anti-condensation' (only for model N3150) ...............................................................................................................................5e
Error code ................................................................................................................................................................................................5f

Removing Air From the Propane Gas Supply Lines

For safety reasons, the burner is made to ignite on propane gas within a specifi ed amount of time. When starting the refrigerator for
the fi rst time, after storage, or after replacing propane gas tank, the propane gas supply lines can have air in them. Due to the air in the
gas supply lines, the burner may not ignite on propane gas within the specifi ed amount of time.
To remove the air from the propane gas supply lines:
- Make sure that all of the gas valves are open.
- To turn the refrigerator on, push the on/off switch and hold it for 1 second, as illustrated.
A light in the on/off switch will turn green.
- Push the source button several times, as illustrated. Push until the fl ame
the display. This means that the refrigerator is operating on propane gas.
- The refrigerator will start a 30 second trial for ignition. During the 30 second trial for
ignition, the refrigerator controls open the gas safety valve and the igniter sparks. After
30 seconds, the refrigerator controls close the gas safety valve and the igniter stops
sparking.
- If the air in the propane gas supply lines prevents the burner from ignition on propane
gas, the fault code
- Push the on/off switch, as illustrated, and hold it for 2 seconds to turn the refrigerator
off. All lights will go out.
- To start another trial for ignition, push the on/off switch and hold it for 1 second to turn
the refrigerator on. A light in the on/off switch will turn green.
- The refrigerator will start another 30 second trial for ignition. During the 30 second trial
for ignition, the refrigerator controls open the gas safety valve and the igniter sparks.
After 30 seconds, the refrigerator controls close the gas safety valve and the igniter
stops sparking.
- When the fl ame appears on the display and no fault code remains, this means that the
refrigerator is operating on propane gas.
- At this time, all of the air is removed from the propane gas supply lines and you may select AUTO mode of operation if you wish.
- Depending on how much air may be in the propane gas supply lines, you may need to repeat the 30 second trial for ignition two or
three times.
- If the burner does not ignite on propane gas after three attempts, refer to the "Troubleshooting" section of this manual; consult your
local dealer or an authorized Norcold Service Center, if necessary.
3 will appear in the center display.
appears on
Installation and Owner's Manual 27
Art02352
Art02367
Art02353