Skandika Morpheus Mode D'emploi page 51

Body fat
Press this button to start the body fat measurement.
Enter your gender ( gure 21), age, height and weight. Hold both hands on the handsensors during measure-
ment ( gure 22). It will last about 8 seconds until the measurement is nished. After the measurement, the
fat advice symbol, the fat % ( gure 23) and BMI ( gure 24) will be displayed for approx. 30 seconds.
Error messages
"= = " " = =" ( gure 25) means, that the contact to the handpulse sensors (or the chest belt) was not su ci-
ently for a measurement. The reason for this can be that you have not grasped the two sensors correctly.
Start a new measurement with correctly placed hands resp. correctly placed chest belt.
"E-1" means, that no heart rate signal has been detected.
"E-4" appears ( gure 26), if the fat % or BMI values are too low (<5) or too high (> 50).
Fig. 21
Fig. 23
Fig. 25
Notes:
1) This computer has an automatic on/o function so that it switches on when the pedals move or when
any button is pressed, and turns into stand-by mode automatically if no signal has been received for
approx. 4 minutes.
2) In case of any abnormal functions, disconnect the device from power source and reconnect after some
minutes
51
COMPUTER OPERATION MANUAL
Fig. 22
Fig. 24
Fig. 26