Programming The Receiver Operating Frequency; Wall Control Operation - Luminance Brands Kathy Ireland 4th AVENUE LED CF766LBQ00 Mode D'emploi

9. Programming the Receiver Operating Frequency

PROGRAMMING THE RECEIVER
OPERATING FREQUENCY
9.1
Turn the Wall Control ON/OFF Switch (
"OFF" ( O )position .
Restore Electricity to the Ceiling Fan Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box .
Flip the Wall Control's ON/OFF Switch to "ON" (
position .
Within one minute of flipping the Switch to "ON", push
and hold the FAN POWER OFF Button (
seconds to set the Code in the Receiver . The Ceiling
Fan Lights (if installed) will blink to indicate the Wall
Control Code has been paired with the Receiver .
WARNING
!
Fan installation must be completed, including the
installation of the fan blades, before testing the fan
control.
Your Wall Control has full control of your Ceiling Fan
and Light (Figure 35) .
10.1
Flip the Wall Control ON/OFF Switch (
"OFF" ( O ) position . Power will be turned OFF to the
Fan and Light .
Flip the Wall Control ON/OFF Switch to the
"ON" ( ) position . Power will be restored to the Fan
and Light .
NOTE: When the switch is turned back ON the light
and fan will resume operation as they were prior to
the switch being turned OFF.
To turn the Ceiling Fan OFF: Press and release the
FAN POWER OFF (
To set the desired Fan Speed: Press One of the Four
Buttons (., .., ..., ....) to operate your Fan from Low to
High Speeds .
To turn the Light ON and OFF: Press and release the
LIGHT ( ) Button . The Light will turn ON at the Light
Intensity previously selected .
To set the Light Intensity: Press and hold the
LIGHT ( ) Button .
....
) to the
OFF ON
) for 3 to 5

10. Wall Control Operation

....
) to the
OFF ON
) Button .
9.2
If programming is unsuccessful, retry the previous
instructions after cycling the Wall Control ON/OFF
Switch to restart the 1 minute programming time period .
9.3
If still unsuccessful, shut off the Electricity at the Main
Fuse Box or Circuit Breaker Panel and change the
) Wall Control Frequency (page 18) . After changing
the Frequency Settings, repeat instruction 9 .1 of this
section within one minute of restoring the electricity .
POWER
INDICATOR
LIGHT
LIGHT
BUTTON
FAN
POWER
OFF
BUTTON
Figure 35
NOTE:
During Summer Months: run the Fan Counter-
Clockwise, as you look up at it, to direct airflow
downward.
During the Winter Months: run the Fan Clockwise,
as you look up at it, to direct airflow upward.
NOTE: For 3-way Installation: BOTH wall controls
ON/OFF switch must be in the "ON" position for
either control to function. With both wall controls
"ON", the fan and light can be operated as
described from either wall control.
NOTE: If your fan and light go ON and OFF without
using your control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems. To remedy
this situations, simply change the transmitter code
per 7.2 Section.
Please contact 1-800-777-4440 for further assistance
23
HIGH TO
LOW FAN
SPEED
BUTTONS
ON/OFF
SWITCH
O = OFF /
— = ON
luminancebrands.com
ETL Model No.: CF766L