Phonebook; Telephone Numbers; Options; Dial Options - Bentel Security BGSM-100 Mode D'emploi

Phonebook

The Telephone Page phonebook holds 100 telephone numbers.

Telephone Numbers

† Description: enter an alphanumeric string of up to 16 characters.
† Telephone number: enter a telephone number of up to 16 digits, preceded by the correct international prefix in the format
"+xxx" (only digits and "+" signs are accepted).
† Activates Output: select the telephone numbers which should activate Output OC3 (T3) when the Communicator receives
a call from these. This function does not depend on the White List or Black List options (Options page->Dial options).
† White List: enable ; ; ; ; ; or disable … … … … … the White List area would allow the Communicator to accept or refuse incoming
calls. The functioning mode of the White List option is linked to the ; ; ; ; ; selection or non-selection … … … … … of the Black List,
area which is present on the inside of the Options page->Dial options, as seen in the following table:
White List
…
…
;

Options

This page is used to set the options relating to the BGSM-100 board.

Dial options

This part is used to enter some of the characteristics relating to the telephone numbers used.
† Prefix: this Device will prefix the digits entered in this field to all the telephone numbers dialled through the GSM Interface
function. If necessary enter a Prefix (maximum 8 digits) in this field. If no Prefix is required, leave this field empty.
† Digits to Remove: if this Communicator is connected downstream to a switchboard, the telephone numbers (programmed
on the Control panel) must be preceded by the switchboard number (normally one digit). As the switchboard number is
not required when calls are sent over the GSM Network, it must be removed from the digits which form the telephone
number. Enter the number of digits that form the switchboard number (e.g. if switchboard number is 01, enter 2 in the
"Digits to remove" field, as 2 numbers form the switchboard number).
, , , , , The telephone number should at least have two digits more that the number in the "Digits to remove" area,
otherwise the engaged tone will be come through, e.g.:
– the dialled telephone number is 0123, with 2 digits to be removed = correct, the remaining number to be
inserted is 23.
– the dialled telephone number is 123, with 2 digits to be removed = engaged tone, the remaining number
to be inserted is 3.
† Enable Black List: check this box if you do not wish to receive calls from stored telephone numbers, authorising only
the numbers selected previously using the White List function (Options page->Dial options).

Generic

This section may be used to set the audio levels of the loudspeaker and microphone fitted to the GSM transmitter.
† Speaker volume: the volume of the loudspeaker may be adjusted by shifting the cursor.
† Microphone volume: the volume of the microphone may be adjusted by shifting the cursor.
† Tones...: select the name of Communicator's country of installation; the selected country will establish a series of
parameters for the proper working of the simulated telephone call.
BGSM-100
Black List
…
Accept incoming calls from any number
;
Refuse any incoming call
Accept incoming calls only from numbers having an enabled
;
White List option, refuse call coming from all other numbers
Functioning mode
G G G G G
27