Introduction; Features; Technical Specifications - Bentel Security BGSM-100 Mode D'emploi

The BGSM-100 is a GSM communicator which, in the absence of a PSTN line, sends vocal or digital alarms, via GPRS,
to a System III or System II receiver. The BGSM-100 is available in three versions:
— The BGSM-100KCA kit including GSM/GPRS communicator electronic card and antenna with 25 cm wire;
— The BGSM-100KEA kit including GSM/GPRS communicator electronic card, antenna with 2 mt wire and metal support.
— The BGSM-100BA kit, including GSM/GPRS communicator, antenna with 25 cm wire and casing;
All information relating to a specific version shall be attested to by reference to the the corresponding code. The word
"Communicator" is being used to describe functions which are common to the various versions.
This manual provides programming and operation of the BGSM-100 GSM/GPRS alarm Communicator.
If there are any special installation requirements, the remote ANT-EU outdoor antenna and the magnetic BGSM-100CA
antenna with 25 cm wire may be used.
, , , , , This Communicator is fixed and shall be installed by Service Persons only (service person is defined as a
person having the appropriate technical training and experience necessary to be aware of hazards to which that
person may be exposed in performing a task and of measures to minimize the risks to that person or other
persons). It shall be installed and used within an environment that provides the pollution degree max 2, over
voltages category II, in non-hazardous, indoor locations only. This manual shall be used with the Installation
Manual of the alarm control panel. All instructions specified within that manual must be observed.

Features

€ Simulates land line
€ Switches automatically to GSM Network in the event
land line trouble (line down)
€ Manages and signals Incoming/Outgoing calls
€ GSM signal indicator
€ 3 programmable Open Collector Outputs
€ Land line overvoltage protection
€ GSM Quad-Band
€ Antenna with magnetic base
€ Supports Contact ID communication format from a
connected control panel for communication over the
GPRS network

Technical Specifications

The input voltage to this can be drawn from the Control Panel or provided by the ADP1512 power supply (not supplied).
Input Voltage
Standby current
Alarm (Transmitting) current
Outputs
Operating frequency
Maximum loop resistance of line
between the device connected in series on LI
Maximum number of parallel devices
connected on LI
Operating Temperature
P.C.B. dimensions
P.C.B. weight
18

INTRODUCTION

€ GPRS/Internet communication with receivers Sur-Gard
€ 4 phone numbers programmable for Contact ID Dialer
€ Up to 100 telephone numbers (max. 16 digits)
€ Remote activation of the outputs through caller
€ PC-programmable options
100 mA maximum (not including the outputs) at
200 mA maximum (not including the outputs) at
System III / II
on GPRS
programmable for the remote activation of the OC
output
identification
between 9.6 and 27.6 V
13.8V dc
13.8V dc
3 open collector, 100 mA
900/1800 MHz or 850/1900 MHz
1 Kohm
2
5 to 40 °C / 41 to 104 °F
60.45 x 142 mm
77g
GSM/GPRS Alarm Communicator