Publicité
Les langues disponibles
Les langues disponibles
Surface of Downdraft Vent
To avoid damaging the finish, clean
downdraft vent with soap and water or
Stainless steel cleaner.
Do not use scouring powder or abrasive
solutions.
Grease Filter Care
Frequently remove and clean the filters in the
retractable section of the downdraft vent. This
will improve the operating efficiency of the
downdraft vent system.
To Remove Filters:
1. Place fingertips in the embossment at the
top for the filters.
2. Press down on the filters far enough for the
tab at the top of the filters to clear.
3. Pull forward to release the filter from its
groove.
To Clean:
1. Remove the filters and clean them in a
dishwasher or in a hot detergent solution.
The downdraft vent will not operate when the
filters are not in place.
2. Dry the clean filters and reinstall, making
sure that they lock into place.
To Replace Filters:
1. Place filters into the retractable section of
the downdraft vent.
2. Place fingertips into the embossment at the
top of the filters and push down and back to
allow the top tabs to snap in place.
NOTE: Downdraft vent will not operate if the
filters are not in their proper position. If the
filters top tabs are not locked behind the top
flange, the vent may retract but not raise back
up.
If retractable downdraft vent does not
operate after clean filters have been
installed:
Push the filter in as far as it will go. When the
filter is removed, the microswitch behind the
filter is inactivated. This feature will not
allow the vent system to operate until the filter
is properly installed.
DOWNDRAFT SYSTEM CARE
A- Grease filter removal tab
B - Left grease filter
C - Right grease filter
WIRING DIAGRAM
Version 6/12 - Page 19
Publicité
