Publicité
Les langues disponibles
Les langues disponibles
The retractable downdraft vent system is designed
to remove smoke, cooking vapors and odors from
the cooktop area.
- For best results, the vent should be operating
before cooking is started.
- If you use large or tall utensils, place them on the
large rear element or burner surface.
- A higher heat setting than normally used may be
needed when the downdraft vent is operating.
Operating Downdraft Vent
To Use:
- Push and hold the button on top of downdraft vent
for a few seconds. (This slight delay helps avoid in-
advertent raising of the vent during cleaning of the
cooktop area.) The retractable section of the
downdraft vent will rise. The blower will begin to
vent immediately if the blower control knob slider is
set to an "On" position.
- Slide the control slider on the right-hand side
of the downdraft vent to adjust the blower motor
speed.
- For Trouble shooting, see PAGE 16
When cooking is complete:
- Push the button on top of the retractable
downdraft vent. The blower will turn off, and the
retractable section of the vent will return to the
closed position.
If a spill occurs on the cooktop that allows liquids
to seep inside the downdraft vent, you must turn
the downdraft vent off immediately. It is possible to
cause damage to the downdraft vent if water is
allowed inside the downdraft vent while it is
operating. Please follow these steps:
- Immediately turn off the downdraft vent at the
speed control located on the right-hand side of the
downdraft vent.
- Turn off the power supply to the downdraft vent at
the circuit breaker box or fuse box.
- Allow plenty of time for the downdraft vent to dry
naturally. Do not open the downdraft vent to
remove the water.
DOWNDRAFT SYSTEM USE
To Replace Filters:
1. Place filters into the retractable section of
the downdraft vent. (E in FIGURE 35)
2. Place fingertips into the embossment at
the top of the filters and push down and
back to allow the top tabs to snap in place.
NOTE: Downdraft vent will not operate if the
filters are not in their proper position. If the
filters top tabs are not locked behind the top
flange, the vent may retract but not raise
back up. If retractable downdraft vent does
not operate after clean filters have been
installed:
- Push the filter in as far as it will go. When
the filter is removed, the microswitch behind
the filter is inactivated. This feature will not
allow the vent system to operate until the
filter is properly installed.
A- Top trim
B - On / Off button
C - Blower control slider
D - End cap
E - Grease filters
FIGURE 36
Version 6/12 - Page 18
Publicité
