Faber SCIROCCO PLUS SCIR3014SS Instructions D'installation page 14

INSTALLING IB500 IN BACK OF THE HOOD
The blower box can also be installed on the
back of the hood to accommodate the
installation of a cooking range or range top in
front of the hood.
- Remove the large cover on the back of the
hood. (FIGURE 23)
- Turn the venting collar on the blower box to
the desired direction - left, right, down. Plug in
the wiring cable from the motor kit to the hood
and Mount the blower box to the housing
using 4 screws . (FIGURE 24)
- When finished, mount the previously
removed cover onto the front of the unit
(FIGURE 25)
FIGURE 25
PRODUCT INSTALLATION
FIGURE 23
FIGURE 24
PREPARE ELECTRICAL CONNECTION
- Remove the cover of the terminal box
(FIGURE 26)
- Decide whether the power source should
enter the hood from below or from the back.
Remove the respective knock out
- If the hood is being installed with a remote
blower, remove the knock out for the control
cable
- Install a UL listed clamp or conduit fitting in
the knock out (not included) (FIGURE 27)
- With assistance for another person lift the
hood into the cabinet cut out. The top
mounting angles should rest on the counter
- Secure the hood to the floor and countertop
(FIGURE 28) with screws into the previously
drilled holes
FIGURE 26
FIGURE 28
FIGURE 27
Version 6/12 - Page 14