Publicité
Les langues disponibles
Les langues disponibles
14. Transport
Pull the plug out of the earthed mains socket.
Remove all objects and inserts from the interior of the appliance.
Screw in the adjustable feet (5).
Tape the door shut.
Where possible, always transport the appliance upright. If tilted to an angle of more
than 40° during transport, wait 4 hours before connecting it to the mains and switching
it on to enable the refrigerant circuit to settle after transport.
15. Troubleshooting
Faults may occur during operation. Please use the following table to check whether you
can resolve the problem yourself. All other repairs are prohibited and invalidate the
warranty. Therefore, in the event of a fault, contact our Service Centre or another suitable
professional repair workshop.
Fault
The appliance is
not working.
The temperature is
not low enough.
The temperature is
not low enough.
The appliance
makes too much
noise or vibrates.
Temperature
control is not
working.
60 - English
Cause
Interruption in the
electrical circuit.
The door does not seal
properly or is opened
too often.
The appliance has been
set up in a location
exposed to direct
sunlight or next to a heat
source.
The appliance has not
been set up properly.
The temperature sensor is
defective.
Solution
Check whether the mains plug is
plugged in.
Check that the connection cable
is not damaged.
Arrange chilled goods so that it
does not prevent the door from
closing properly.
Open the door for less time.
Check the door seal.
Place the appliance in a
different position.
Set the appliance to a higher
refrigeration level.
Level.
Contact the Service Centre.
Publicité
