SilverCrest SMK 41 A2 Mode D'emploi page 52

Climate class
ST
T
8.1. Information regarding refrigerant R-600a
R-600a and cyclopentane are used as 100% HCFC-free refrigerant and insulating
materials in this appliance. This helps to protect the ozone layer and reduces the so-called
greenhouse effect.
These appliances can be identified by the "Refrigerant R-600a" notice on the type plate.
 Ensure that the refrigerant circuit is not damaged, as small quantities of R-600a can
contribute to the greenhouse effect if released.
 This applies both when transporting the appliance and throughout its service life. Also
ensure that you dispose of this appliance correctly according to local regulations.
9. Before operation
 Unpack the appliance and remove the adhesive tape.
Use a mild cleaning agent to remove any adhesive residues.
 Dispose of the expanded polystyrene padding separately from the other packaging.
 Rinse the inside of the appliance and the fittings with lukewarm water and mild
cleaning agent and allow to dry (see section "13. Cleaning the appliance" on page
59).
9.1. Changing the door hinge over to the opposite side
The refrigerator is supplied with a door hinged on the right-hand side. If you would like to
change the door hinge over to the opposite side, proceed as follows.
Required tools:
• Wrenches (width across flat of 8 mm and 10 mm)
• Small flat-head screwdriver
• Phillips screwdriver
The mains plug has been unplugged.
 Empty the refrigerator – including the shelf.
 Remove the hinge cover on the right-hand side, for example using a flat-head
screwdriver (see Fig. B).
 Use a Phillips screwdriver to loosen the three screws on the upper hinge (10) (see
Fig. C).
 Remove the screw hole cover on the left-hand side, for example using a flat-head
screwdriver (see Fig. D).
 Remove the dummy plug for the hinge pin from the left-hand side of the appliance door
and insert it in the hole on the right-hand side (see Fig. E).
Appliances for subtropical climate
Appliances for tropical climate
Meaning
English -53