SilverCrest SMK 41 A2 Mode D'emploi page 43

3.3. Installation and electrical connection
3.3.1. Location
NOTICE!
Possible material damage!
Risk of damage to the appliance due to improper handling.
 Set up the refrigerator in a dry and ventilated room. The room
should be approx. 4 m² to ensure that sufficient air volume is
available if the cooling system becomes damaged.
 Take the space requirements into consideration when setting up the
appliance (see "9.2. Setting up the appliance" on page 54).
 The appliance is suitable for climate classes N/ST (see the type
plate). The cooling performance of the appliance is guaranteed
at ambient temperatures from 16 °C to 38 °C. If temperatures
deviate from this range, the appliance performance may be
reduced.
 Never place the appliance with the front edge along the edge of
a table top or shelf, because there is a risk of the appliance tipping
forwards and falling if the door compartment is overloaded.
Take care to ensure that there is adequate space in front of the
appliance so that when opening the door, the door lies on the
storage surface when the appliance is tipped. Always load the
cooling chamber first and then the door compartment.
 Do not expose the appliance to extreme conditions. Avoid:
− high humidity or wet conditions
− extremely high or low temperatures
− direct sunlight
− open flames.
WARNING!
Risk of fire!
Insufficient air circulation can lead to heat accumulation.
 Make sure that the ventilation openings in the housing, around the
appliance and in the installation niche are not blocked.
44 - English