Publicité
Les langues disponibles
Les langues disponibles
8663817
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
Contents:
•
Pipe/Tube Notcher
•
5/8 in. Hole Saw Adapter
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
1.
Mount the pipe/tube notcher into a vise. Ensure the spindle (#1) is easily
accessible and long pieces of pipe have enough clearance when in the
pipe/tube notcher.
2.
Check that the spindle travels smoothly without binding against the
bushings (#2). Undue friction will cause excessive wear of the bushings.
3.
Thread a bi-metal hole saw blade with a 1/2 in. arbor onto the spindle.
a.
The 5/8 in. adaptor and washer (#5 and #4) can be screwed onto the
spindle's 1/2 in. thread, if needed for a saw blade with a larger arbor hole.
4.
Adjust the spindle support's (#3) position by loosening the two screws
(#21) under the spindle fixed plate (#6) and sliding the support forward or
backward to fit different lengths of hole saw blades. Tighten the screws
once the position is set.
5.
Adjust the fixed clamp (#12) position by loosening the screws (#15) under
the clamp fixed plate (#8) and moving the clamp nearer or farther from the
spindle fixed plate (#6).
a.
Moving the clamp farther from the spindle fixed plate allows a deeper
angle when notching a pipe.
b.
Moving the clamp nearer to the spindle fixed plate allows better
support and reinforcement of the pipe for shallow angles when
notching a pipe.
6
Pipe/Tube Notcher
For technical questions call 1-800-665-8685
V4.1
Publicité
