Publicité
Les langues disponibles
Les langues disponibles
8663817
Pipe/Tube Notcher
SPECIFICATIONS
Material
Degree Range
Offset Notch Range (Vertical)
Chuck Size
Use With Electric Drill
Pipe/Tube Capacity
INTRODUCTION
Make perfect joints for clean, secure welds. The steel frame holds the workpiece
rigid and allows you to make round cuts in pipes and tubes of various shapes.
SAFETY
WARNING! Read and understand all instructions before using this tool. The
operator must follow basic precautions to reduce the risk of personal injury
and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or inspection and
maintenance instructions.
HAZARD DEFINITIONS
Please familiarize yourself with the hazard notices found in this manual. A notice
is an alert that there is a possibility of property damage, injury or death if certain
instructions are not followed.
DANGER!
This notice indicates an immediate and specific hazard that will
result in severe personal injury or death if the proper precautions
are not taken.
2
Pipe/Tube Notcher
Steel
0 to 210° (1° increments)
1-1/4 in.
1/2 in.
1/2 in. Chuck
2-1/2 in.
For technical questions call 1-800-665-8685
V4.1
Publicité
