Panasonic Palmcorder PV-A20-K Manuel D'utilisation page 5

Supplying Power
Battery Refresh Feature
This feature completely discharges Battery before recharging begins.
To maintain your battery's operating capacity, use the refresh feature after every five
charges.
REFRESH
Lamp
AC Adaptor
DC Power Cable
POWER Lamp
DC OUT
Connector
Note:
• While the DC Power Cable (supplied) is connected to the AC Adaptor, the Battery cannot
be charged.
• While not in use, unplug the AC Adaptor from the AC outlet. (AC Adaptor consumes
1.2 W of electric power if it is plugged into an AC outlet even when not in use.)
1
Plug in the AC Adaptor.
POWER Lamp lights up.
Note:
• Please do not unplug the AC cord during
refresh so as not to terminate the refresh
function.
2
Place the Battery into the AC Adaptor.
3
Press the REFRESH button.
The REFRESH Lamp lights, then goes
out when discharging is complete. Battery
charging will then start automatically.
4
Remove the Battery.
• Should you accidentally press the
1
Connect the DC OUT on the AC
DC IN
Connector
Adaptor to the DC IN on the
Palmcorder with the DC Power Cable
(supplied).
2
Plug in the AC Adaptor.
• The POWER Lamp will light up.
REFRESH button, remove Battery and
then re-insert it to begin charging.
APPROXIMATE REFRESH AND
RECHARGE TIME:
PV-BP18-K Seven and one half hours
PV-BP15-K Five hours
HHR-V20 Eight hours
HHR-V40 Sixteen hours
HHR-V60 Twenty-four hours
5